JVC XMG6
Owner's Manual

Continued

Recording a Tape
When recording from TD-UXG6 cassette deck, you can select one of the two recording methods � Manual Recording (stereo) and Sound Synchronized Recording. � Manual Recording � Sound is recorded in stereo (both on the left and right audio channels). You have to operate the MD recorder and the cassette deck respectively. � Sound Synchronized Recording � With this method, you can start recording when the sound signals come into the MD recorder (sound is recorded in stereo). Sound Synchronized Recording will stop automatically if no sound comes in for more than 30 seconds.
If Sound Synchronized Recording will not work correctly Use the Manual Recording. Sound Synchronized Recording starts automatically when the MD recorder detects sound signals come in. If sound signal is too weak for this unit to detect, Sound Synchronized Recording will not start (or will stop even while the source is being played).

� To stop recording temporarily, press REC PAUSE button or 6 (play/pause) button on the MD recorder or MD 6 (play/pause) button on the remote control. � To resume recording, press 6 (play/pause) button on the MD recorder or MD 6 (play/pause) button on the remote control again.
Each time you press DISPLAY/CHARA. button, information switches between the remaining time for the recording and the elapsed time with the track number of the MD alternately.

6

Press 7 (stop) buttons both on the MD recorder and the cassette deck to quit recording as required. �WRITING� appears in the display window, and you can remove the MD and the tape by pressing 0 (eject) buttons. Using 7 (stop) button on the remote control, you cannot stop both the MD recorder and the cassette deck. Make sure to press each button on
both units.

Recording a Tape Manually

1 2

Insert a recordable MD into the MD loading slot. The MD IN lamp lights orange. Prepare a tape playback. � Place a tape on the tape tray, press ` (playback) button on the cassette deck or TAPE ` (playback) button on the remote control, then press 7 (stop) button before going to the next step. Press REC PAUSE button on the MD recorder. The REC indicator on the MD recorder lights red, and the MD recorder switches to the recording-pause mode. Press 6 (play/pause) button on the MD recorder or MD 6 (play/pause) button on the remote control. The MD recorder starts recording, and information changes in the display window and the remaining time for recording appears as follows:

Recording a Tape � Sound Synchronized Recording
Setting the recording mode, you can start playing back a tape and recording it onto an MD simultaneously.

1 2

Repeat the steps 1 and 2 in the previous section on this page. Press REC MODE button behind the sliding panel to select a recording mode as follows:

3 4

3

Press SET button. REC indicator on the MD recorder lights red, and information appears in the display window as follows:

5

Press ` (playback) button on the cassette deck or TAPE ` (playback) button on the remote control in succession.

15