Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
Text excerpt from page 43 (click to view)
Messages do not appear on the screen in the language you want. � Select the language you want for the on-screen display in �OSD� under �Language� in the Setup Display (page 19). The language for the sound track cannot be changed. � Multilingual tracks are not recorded on the DVD being played. � The DVD prohibits changing the language for the sound track. The subtitle language cannot be changed. � Multilingual subtitles are not recorded on the DVD being played. � The DVD prohibits changing the subtitles. The subtitle cannot be turned off. � The DVD prohibits turning off subtitles. The angles cannot be changed. � Multi-angles are not recorded on the DVD being played. � The DVD prohibits changing the angles.
Tape deck
The tape does not record or play, or there is a decrease in sound level. � The heads are dirty. Clean them (page 46). � The record/playback heads are magnetized. Demagnetize them (page 46). The tape does not erase completely. � The record/playback heads are magnetized. Demagnetize them (page 46). There is excessive wow or flutter, or the sound drops out. � The capstans or pinch rollers are dirty. Clean them (page 46). Noise increases or the high frequencies are erased. � The record/playback heads are magnetized. Demagnetize them (page 46). The tape does not record. � No cassette is loaded. Load a cassette. � The tab has been removed from the cassette. Cover the broken tab with adhesive tape (page 46). � The tape has wound to the end. � Set �Dolby Digital� or �DTS� under �AV� to �PCM�. �TAPE ERR� appears in the display. � Press ?/1 to turn off the system and remove any tapes from the cassette holder. Then disconnect the power cord and reconnect it. Then press ?/1 to turn on the system. If �TAPE ERR� still appears, consult your nearest Aiwa dealer.
Tuner
Severe hum or noise/stations cannot be received. (�TUNED� or �STEREO� flashes in the display) � Set the proper band and frequency (page 24). � Connect the antenna properly (page 8). � Find a place and an orientation that provide good reception, then set up the antenna again. If you cannot obtain good reception, we recommend you connect a commercially available external antenna. � The supplied FM lead antenna receives signals along its entire length, so make sure you extend it fully. � Locate the antennas as far away from the speaker cords as possible. � Consult your nearest Aiwa dealer if the supplied AM antenna has come off the plastic stand. � Try turning off surrounding electrical equipment. A stereo FM program cannot be received in stereo. � Press FM MODE until �MONO� disappears.
Optional components
There is no sound. � Refer to General item �There is no sound.� (page 40) and check the condition of the system. � Connect the component properly (page 37) while checking: � if the cords are connected properly. � if the cord plugs are firmly inserted all the way. � Turn on the connected component. � Refer to the operating instructions supplied with the connected component and start playing.
