Very good quality pdf file, no missing pages and all words and schematics clearly readable. Whole manual is present featuring different languages.
Text excerpt from page 95 (click to view)
5
6
7
8
TRAVERSE MECHANISM ASSY-S Disassembly 1 2
Remove the Bonnet (Screws � 11) Remove the Tray Cap Remove the Front Panel Section (Refer to " FRONT PANEL SECTION")
A
8
Unhook
CN12
9 7
TRSB Assy
9
Unhook
B
3 4 5 6 7 8 9
10
Power ON Tray Open (0 OPEN/CLOSE) Pull out the power cord from the outlet. Push the Tray by hand. (about 5 cm) Bring an extra flexible cable close to the rear side. Disconnect the flexible cable. Note : The Traverse mechanism being an unclamp (=down) state.
C
Unhook � 2 Pull out the tray while pressing the two hooks ( 9 ).
10
6
Tray Section
D
When Tray Cannot Pull Out
Tray cannot pull out that is not at a position of home position. (When two hooks ( 9 ) hide under the Rotary Tray and can not pull out the tray.) In that case, set the tray in the following procedures. 1 Remove
3
Tighten
E
Note : Do not need to match with Disc No. (1 to 5) when returns the tray. Detect it automatically.
Rotary Tray
2
Set the tray to the position that can see a hole of the center.
