|
|
|
Who's Online
There currently are 5712 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I'm very satisfied with your manual service. Your website made it easy to locate the correct manual. Also the quality is great and I never had a problem reading the fine details.
Thanks again.
Jeff Miller
JM Electronics
 ;
Good quality service manual German user manual. German user manual This is a quality scan of a manual in excellent condition and is just as good as having the original manual in hand
;
The manual for Sony LBT-D505 component stereo system is was excellent , with schematics, parts layout and parts list as well as instructions for adjustments for each component. Print was clear even when enlarged.
;
It's exactly a complete and very useful manual with all details what I needed. Thank you!I will come back whenever I need your manuals or schematics.
;
I searched EVERYWHERE looking for the manual/s on this "extinct" amp. Owner-Manuals.com made it available and for nearly nothing. Thanx to them, I can decipher the unknown cables and sort them out. Thanx, Owner-Manuals.com!!
1
2
3
4
7.1.2 NOTES ON REPLACE OF PARTS
A
(ID-related) The ID number for an individual product is stored in the EEPROMs (U7 for the TX module, U11 for the RX module) of each module (TX module: AXF7006, RX module: AXF7008). It should be noted that wireless communications cannot be performed unless these ID numbers are identical.
1. Replacement of the TX or RX module
Upon replacement of the TX (AXF7006) or RX (AXF7008) module, remove the EEPROM from the original module and mount it on the new one.
2. Replacement of the EEPROMs (U7 and U11)
Using service part AXX7169 (a kit containing two EEPROMs with identical ID numbers stored in them,) replace both EEPROMs when either needs to be replaced.
B
Note : The AXX7169 is a service part containing two EEPROMs, both of which must be replaced when either needs to be replaced.
7.1.3 DIAGNOSIS OF THE AMPLIFIER SECTION
You can diagnose the amplifier section even if the transmitter section is not available. Input audio signals to the Jumper Wire for service use indicated below. At that time remove the RX MODULE.
W141 LW142 L+
C
W155 R-
VA+9 13 CN3051 1
1 pin
B MAIN ASSY
SIDE A
1 3
Jumper Wire for service for signal input
W127 VREF Ch.SEL
CN3701
W195 W194 W139 W193
L GND R
1 4
W156 R+
W143 GNDP
W126
E
W140 V+9RF
F
60
1 2
XW-HTD630
3 4
3401
4 1
D
PNE-1B1
CN5
CN5901
1
1 12 1 1 12 1 2 13
3
servicefor
Wh
|
|
|
> |
|
