Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
Text excerpt from page 13 (click to view)
To clean the Pleated Filter:
1. Remove the �lter assembly by grasping handle and lifting upward and out of the dust cup. 2. Grasp the pleated �lter and turn counter clockwise to remove. 3. Lift pleated �lter from cone and wash. Shake excess water from �lter. Do not submerge �lter assembly � wipe only with a damp cloth. 4. When all parts are completely dry, replace pleated and turn clockwise to lock in place.
Pleated Filter
Filter Assembly
FOR INSTRUCTIONS ON HOW TO REMOVE THE CYCLONIC DUST CUP FROM THE CLEANER BODY, REFER TO PAGE 12.
Emptying the Cyclonic Dust Cup:
It is clearly visible when the dust compartment is full and needs emptying. Remove dust cup from cleaner body and dump debris in a waste container.
Reinstalling the Cyclonic Dust Cup:
To mount �lter assembly into cleaner body, make certain �lter assembly is fully seated in top of dust cup. Replace dust cup by aligning front of the bottom of dust cup into groove on cleaner. Pivot dust cup up against cleaner and rotate the dust cup latch to the right to secure.
CAUTION: The dust cup can be washed in warm water, if desired, but strong detergents should not be used. Dry
thoroughly before using again. Do not submerge �lter assembly, wipe only with a damp cloth.
