Finding the owners manual for my Pioneer CRWM62R is greatly appreciated. I had searched several other web sites with no success. Although my manual was not listed on your site for immediate download, I recevied an email within a few hours that my ower's manual was posted for me. I had no difficulty downloading the manual for my 20 year old multi-cassette player. Owner Manuals provides a service that is valuable, easy-to-use, accurate , efficient, and priced fairly. I thank you.
Easy to access. Clear instructions. No problems. Printed fine.
Text excerpt from page 18 (click to view)
Electrical connection
The unit is preset to work with a voltage of single phase 230 V. Before making the connection make sure that: the energy power available in the user's house is sufficient for the normal supply of this appliance (see rating plate). The unit is correctly connected to earth through a suitable plug and according to the installation country Laws. The socket or the omnipolar switch used for the connection must be easily reached with the installed appliance. The appliance is supplied without electric cord: consequently, you have to install a plug fit for the load shown in the serial number plate. The plug has to be connected to an adequate socket. If you wish to directly connect to the mains, you have to interpose an omnipolar switch with a minimum opening between contacts of 3 mm, between the unit and the mains, complying with the existing regulations. The brown live wire (originating from the clamp of the cooker junction box) must always be connected to the phase of the mains supply. In any case, the supply cord must be positioned in such a way as it doesn't reach in any point a temperature higher by 50°C than the room temperature.
FO 0480
Replacement of supply cable
Should the supply cord need to be replaced, use only cables of the following types: H07 RN-F, H05 RN-F, H05 RR-F, H05 VV-F, H05 V2V2-F (T90), H05 BB-F Moreover, it is necessary that the yellow/green earth wire is about 2cm longer than the live and neutral ones (Fig. 29). After the connection, test the heating elements for about 3 minutes to ensure that they are working correctly. The manufacturer refuses any responsability in cases where normal safety measures are not observed. Fig. 29 Neutral wire
