Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
Text excerpt from page 5 (click to view)
Changing the opening direction of doors and Panelling
If your refrigerator has top panel, you can manage in the same way from point 1 to point 7 and then: 8... Unscrew the axle of the upper hing (9) and replace it at the opposite side (10). For the remaining parts proceed the other way round. Once finished make sure that all joints close perfectly well all around the door and chek that the internal light turns of when the fridge door closes.
How to panel the door:
If your appliance is provided with metal strips for panelling and you wish to do so proceed as follows: 1... Remove one of the side strips. 2... Loosen the screws of the remaining strips. 3... Start putting on the panel where you took off the strip pushing it right up to the end. 4... Replace the strip on this side. 5... Tighten all screws NOTE: The panel dimensions must be 2 mm. shorter than the doors. Maximun thickness of the panel is 4 mm.
