The service manual when downloaded and printed out was clear and easy to read. The manual is complete with the schematic diagram and technical data. I occasionally require a manual and now having registered with this company I shall order from them in the future.
Great manual, great price. I am very pleased with Owner-Manuals.com, quick service, fast communication. Will definitely use this site again.
Text excerpt from page 4 (click to view)
INSTALLATION
If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Fig. 2
Location
Place the appliance as far away as possible from sources of heat, e.g. radiators, heaters, direct sunlight, etc.. The best results are achieved with a room temperature ranging from +18°C to +38°C (class ST) or from +18°C to +43°C (class T). The class of your appliance is shown on its rating plate. Make sure that there is nothing at the back, at the top and at the bottom of the appliance to obstruct air circulation. For more ef�cient operation of the appliance the minimum distance between the top of the appliance and other overhanging kitchen furniture, if any, should be at least 100 mm (Fig. 1-A). The best solution is shown in Fig. 1-B (without overhanging kitchen furniture). The appliance sides may also be in contact with the kitchen furniture, provided that air can circulate freely round the back and top. One or more adjustable feet mounted on the base of the appliance make it possible to set it perfectly level. Fig. 1
D060
A
45°
Power connection
Before plugging the appliance into the mains socket, check that the voltage and frequency indicated on the appliance�s rating plate are the same as those provided by your home power supply. A 6% �uctuation above or below rated voltage is acceptable. Make sure the plug and the socket are compatible so that no adaptors need to be used. If necessary, replace the socket with a suitable one. The appliance MUST be connected to an ef�cient earth or ground tap. The supply-lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a quali�ed electrician, in accordance with existing safety regulations. The manufacturer declines to accept any liability if this accident-prevention procedure is not followed. This appliance complies with the relevant UNI standards and with E.E.C. Directive No. 87/308 of 02.06.87 relative to radio interference suppression. This appliance complies with the following E.E.C. Directives: - 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modi�cations; - 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modi�cations.
A
100 mm min.
B
D194
Rear spacers
In the plastic envelope containing the Operating Instructions are also included two wall spacers to be �tted into the special openings provided on the back of the appliance (Fig. 2). Push-�t the spacers into the openings, making sure that arrow (A) is positioned as per Fig. 2 and then turn the spacers through 45° until they lock in (arrow in vertical position).
Cleaning the appliance�s interior
Before using the appliance for the �rst time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then dry thoroughly. Do not use detergents or abrasive powders as these will damage the �nish.
