Genuine Toshiba owner's manual. Couldn't really ask for more. And written in understandable English in contrast to a few recent experiences I have had with manuals for other equipment other than Toshiba but made in China and written in "Chinglish"!
I purchased a vintage Sony mixer off eBay and within the hour was able to locate and purchase the manual for it.I mean really,where else can you find a manual for a product made in 1983!? It was easy to find and purchase/download the manual I needed.I will use this site again for other equipment I have! Great site!
It`s full copy of a service manual from url http://www.philips.owner-manuals.com/PM3216-service-manual-PHILIPS.html
Text excerpt from page 3 (click to view)
Installation
Positioning
� Place the refrigerator away from direct sunlight and heat sources. � Maintain recommended ventilation - see Fig. 1. � Make sure the refrigerator is accurately levelled turning the adjustable feet in order to avoid vibrations and noises. � This is a built in design to be aligned with other furniture
Cleaning the interior
� Do not use alcohol or any cleanig product containing alcohol because it can damage the cabinet. � Before using the appliance for the first time wash the interior with luke warm water and some neutral soap so as to remove the typical smell of a brandnew product arid then dry thoroughly. � Do not use detergents or abrasive powders as these will damage the finish. � Remove security used for transportation.
Fig. 1
Electrical connection
mBefore plugging the appliance make sure that the voltage and frequency shown on the «Technical Features» correspond to your home supply. mIt is essential that the appliance be efficiently earthed. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not grounded, have the appliance connected to a separate ground wire in accordance with existing safety regulations. «THE MANUFACTURER DECLINES TO ACCEPT ANY LIABILITY IF THIS SAFETY RULE IS NOT OBSERVED». Should a change of the supply cord be necessary, remove the lid of the terminal board acting on «E» and «F» as shown figure 3 in order to gain access to the terminals. Fig. 3.
Fig. 2
Starting � up
� Plug the appliance into the mains. � Make sure the inner light «H» turns on when opening the door. � Turn to intermediate position the knobs of the «temperature regulators» «f» for refregerating compartment and «e» for freezing compartment.
