I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Text excerpt from page 3 (click to view)
Changing the opening direction of doors
If you wish to change the opening side of the doors proceed as follows: 1... Take off the plinth (A) pressed onto cabinet. Take out the lid (B) and put it into the opposite hole. 10...Place the lower door next to the lower hinge (C) in the opposite side from original and fix all the hinges. Before it, using a 10mm spanner, unscrew the hinge pin and reassemble it on the opposite side.
B
C
C
A B
PR1
C
11...Dismantle the vertical handles and assemble them in the opposite side. Cover the holes with the plastic lids that were situated where the handles are presently.
2... Remove the lower hinge (C) taking care for the lower door not to fall off. 3... Lift the lower door off the central hinge (D).
D
4... Remove the central hinge (D) taking care for the upper door not to fall off and not to lose the plastic washer. 5... Take the upper door off the upper hinge (E). Be carefull not to lose the plastic washer.
PR220
12...Replace the plinth (A) well fixed.
mOnce finished make sure that all joints close
perfectly well all around the door and chek that the internal light turns of when the fridge door closes.
E
6... Unscrew the plastic plugs located on the opposite side of the central hinge and introduce them in the holes occupied before by the hinge. 7� Unscrew the axle of the upper hing and screw it into the hinge on the opposite side. Make sure to fit in the metal washer for blocking. 8� Place upper door. 9... Put the central hinge (D) in the opposite side from original position. Leave the hinge loose.
