There are currently no product reviews.
Notes on CDs
Precautions
On safety
� As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only. � Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. � Discs with non-standard shapes (e.g., heart, square, star) cannot be played on this player. Attempting to do so may damage the player. Do not use such discs.
� Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out.
Troubleshooting
General
The power does not come on.
� Connect the AC power adaptor to a wall outlet securely.
The remote does not function.
� Replace the battery in the remote with new one if it is weak. � Make sure that you are pointing the remote at the remote sensor on the player. � Remove any obstacles in the path of the remote and the player. � Make sure the remote sensor is not exposed to strong light such as direct sunlight or fluorescent lamp light. � Move closer to the player when using the remote. After trying the above remedies, if you still have problems, unplug the AC power adaptor. After all the indications in the display disappear, plug the AC power adaptor. If the problem persists, please consult your nearest Sony dealer.
Remote
English
Information
Specifications
WARNING
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION With 6-ohm loads, both channels driven from 1 000 - 10 000 Hz; rated 3.5 W per channel-minimum RMS power, with no more than 10 % total harmonic distortion in AC operation.
For customers in the USA
Owner's Record
The model number and serial number are located at the rear. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No. ZS-D10 Serial No.
To prevent fire or shock hazard, do not expose the player to rain or moisture.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: � Reorient or relocate the receiving antenna. � Increase the separation between the equipment and receiver. � Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. � Consult the dealer or an experienced radio/ TV technician for help. This class B digital device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Replace the AC power adaptor with model ACCD10 only, if replacement is necessary.
There is no audio.
� Make sure the function you want to use appears in the display window. � Adjust the volume. � Unplug the headphones when listening through speakers.
For customers in the USA
� Do not use solvents such as benzine, thinner, commercially available cleaners or anti-static spray intended for vinyl LPs. � Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car. � Do not stick paper or sticker on the CD, nor scratch the surface of the CD. � After playing, store the CD in its case. If there is a scratch, dirt or fingerprints on the CD, it may cause tracking error.
Other specifications
CD player section
System Compact disc digital audio system Laser diode properties Material: GaAlAs Wave length: 780 nm Emission duration: Continuous Laser output: Less than 44.6 µW (This output is the value measured at a distance of about 200 mm from the objective lens surface on the optical pick-up block with 7 mm aperture.) Spindle speed 200 r/min (rpm) to 500 r/min (rpm) (CLV) Number of channels 2 Frequency response 20 - 20 000 Hz +1/�2 dB Wow and flutter Below measurable limit
Noise is heard.
� Someone is using a portable telephone or other equipment that emits radio waves near the player. tMove the portable telephone, etc., away from the player.
Personal Audio System
Operating Instructions
This symbol is intended to alert the user to the presence of uninsulated �dangerous voltage� within the product's enclosure that constitute a sufficient magnitude to may be of risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
Please register this product on line at http:// www.sony.com/productregistration. Proper registration will enable us to send you periodic mailings about new product, services and other important announcements. Registering your product will also allow us to contact you in the unlikely event that the product needs adjustment or modification. Thank you.
Cleaning the cabinet
� Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzine.
CD Player
The CD does not play or �no dISC� lights in the display even when a CD is in place.
Place the CD with the label surface you. Make sure that the CD compartment is closed. Clean the CD. Take out the CD and leave the CD compartment open for about an hour to dry moisture condensation. � Make sure �Cd� appears in the display. � The CD-R/CD-RW was not finalized. Finalize the CD-R/CD-RW with the recording device. � There is a problem with the quality of the CDR/CD-RW, recording device, or application software. � � � �
On power sources
� For AC operation, use the supplied AC power adaptor; do not use any other type.
About CD-Rs/CD-RWs
This player can play CD-Rs/CD-RWs recorded in the CD-DA format*, but playback capability may vary depending on the quality of the disc and the condition of the recording device. * CD-DA is the abbreviation for Compact Disc Digital Audio. It is a recording standard used for Audio CDs.
Polarity of the plug � The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. � Unplug the player from the wall outlet when it is not be used for an extended period of time. � When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. � The nameplate indicating operating voltage, etc. is located at the rear.
CAUTION
The use of optical instruments with this product will increase eye hazard.
WARNING
Radio section
Frequency range FM: 87.5 - 108 MHz AM: 531 - 1 611 kHz (Taiwan model) 530 - 1 710 kHz (Other models) Antennas FM: Telescopic antenna AM: Built-in ferrite bar antenna ©2003 Sony Corporation Printed in China
The sound drops out. Noise is heard.
� Reduce the volume. � Clean the CD, or replace it if the CD is badly damaged. � Place the player in a location free from vibration. � Clean the lens with a commercially available blower. � The sound may drop out or noise may be heard when using poor quality CD-Rs/CDRWs or if there is a problem with the recording device or application software.
Music discs encoded with copyright protection technologies
This product is designed to play back discs that conform to the Compact Disc (CD) standard. Recently, various music discs encoded with copyright protection technologies are marketed by some record companies. Please be aware that among those discs, there are some that do note conform to the CD standard and may not by playable by this product. If you have any questions or problems concerning your player, please consult your nearest Sony dealer.
ZS-D10
Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the appliance.
For customers in Canada
To prevent electric shock, match wide blade of plug to wide slot, fully insert.
General
Speaker Full range: 8 cm (3 1�4 in.) dia., 6 �, cone type (2) Input LINE IN jack (stereo minijack): Minimum input level 330 mV Outputs Headphones jack (stereo minijack): For 16 - 68 � impedance headphones OPTICAL DIGITAL OUT (CD) (optical output connector): Wavelength 630 - 690 nm Power output 4 W + 4 W (at 6 �, 10% harmonic distortion) Power requirements For Personal Audio System: DC IN 10V jack accepts: Supplied AC power adaptor for use with: 120V AC, 60 Hz For remote control: 3 V DC, 2 size AAA (R03) batteries Dimensions Approx. 530 � 195 � 127 mm (w/h/d) (20 7�8 � 7 3�4 � 5 inches) (incl. projecting parts) Mass Approx. 2.5 kg (5 lb. 8 oz) Supplied accessory AC power adaptor (1) Remote control (1) Design and specifications are subject to change without notice.
3-251-193-91 (1)
On placement
� Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. � Do not place the player on an inclined or unstable place. � Do not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. � If the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. � Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or spring-wound watches away from the player to prevent possible damage from the magnet.
Lens
Power Sources
B A
Radio
Reception is poor.
� Reorient the antenna to improve FM reception.
1 to DC IN 10V 2 to a wall outlet
On operation
� If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate.
Connect the AC power adaptor A.
� Reorient the player itself to improve AM reception.
Preparing the remote B
Insert two size AAA (R03) batteries (not supplied).
Optional accessories
Sony MDR headphone series
Replacing batteries
With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace two batteries with new ones.
The audio is weak or has poor quality.
� Move the player away from the TV. � If you are using the remote while listening to AM radio, noise may be heard. This is unavoidable.
The picture of your TV becomes unstable.
� If you are listening to an FM program near the TV with an indoor antenna, move the player away from the TV.