This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
Text excerpt from page 18 (click to view)
BUILDING-IN
Building-in features
This dishwasher is designed to be fitted under a kitchen counter or sink. In either case, it is essential that the recess dimensions indicated in the picture are followed. No further openings for venting of the dishwasher are required, but only to let the water fill and drain hoses and power supply cable pass through.
820÷880
600
* 550 *
Mounting of decor panel onto the door The height of the panel depends on the height of the plinth of adjacent kitchen units (see kitchen plinth adjustment).
596 max
596
818÷878
The panel must be fitted with a handle, as the dishwasher handle will be hidden by the panel. Drill the panel with a � 2x12 bit according to the dimensions indicated in the figure.
555x ma
II19
II28
II06
Fix the cross bar onto the panel using four 3.5x16 screws provided. Reduce the length of fixing screws according to thickness of panel. If for aesthetic matching the panel is provided with a false drawer (fitted or carved on the panel itself), the two brackets provided should also be used.
596 max 546 =
The recess height may be anywhere between 820 and 880 mm from the floor since the dishwasher incorporates levelling feet adjustable over a wide range (max 60 mm). Adjust the height of the appliance by turning these feet. A distance of 2 mm should be allowed between the top of the dishwasher and the counter top.
0 ÷ 60mm
=
Fix the brackets according to the measurements shown in the figure, by using four 3.5 x 16 screws.
Fitting under a counter (kitchen worktop or sink)
II17
30 40
It is absolutely essential that the dishwasher is disconnected from the electricity supply before gaining access to any internal component. Fit the dishwasher into the appropriate housing space and connect it. Make sure that the water fill and drain hoses and the power supply cable are not bent or kinked.
Reduce the length of fixing screws according to thickness of panel. Mount the decor panel by inserting the two pivots of the cross-bar into the slotted holes of the door. Lift the decor panel until perfect alignment with the facia panel is obtained: if the two brackets have also II12 been used, they will automatically enagage in the special holes provided on the dishwasher door. Once the correct position has been found, open the door and fasten the decor panel on the lower section by means of the two long 4x40 screws provided, using the holes through the inner door (see fig.).
II10
Fitting the panel onto the door
The door on this model is designed for the overlay of a panel having the following dimensions: Width: Height: Thickness: Weight: Note: The panel height should not be more than what indicated, otherwise complete opening of the door will no longer be possible as the panel hits against the dishwasher plinth. 596 mm 644 to 714 mm max 20 mm max 2 to 7.5 kg max
