Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
Très satisfait ! envoi rapide, Grand catalogue disponible. Many thanks !
Text excerpt from page 13 (click to view)
11. How to change an option or a programme during its cycle
Before you make any change, you must pause the machine by pressing the �Start/Pause� button. It is possible to change the temperature or any option before the programme carries it out. Changing a running programme is possible only by cancelling it and selecting a new programme. The machine will resume the cycle from the beginning and the washing water in the tub will not emptied out. If it is necessary to drain the water, proceed as follows: � PAUSE the machine by pressing the �Start/Pause� button; � press the �Skip/Reset� button repeatedly, until only the �Drain� light remains lit; � press the �Start/Pause� button again. When the water has been drained, the display shows a blinking zero. You may now select a new programme and press the �Start/Pause� button to start it.
After approximately 3 minutes, you can open the door. Pay attention to the level and temperature of the water in the machine! When you close the door and press the �On/Off� button again, the machine will resume the programme from the point where it had been interrupted.
14. End of programme
At the end of the programme, the machine stops automatically, the �Start/Pause� button light goes off and the display shows a blinking zero. If you had selected the �Rinse Hold� option, the �Start/Pause� button light goes off, the �Rinse Hold� button light remains lit and the door is locked to indicate that the water must be drained. The display shows a blinking zero. When the programme has been completed, a blinking zero appears on the display. Press the �Skip/Reset� button repeatedly to erase the programme that has just been carried out. If you omit to do this, the next time you switch the machine on, the blinking zero will appear on the display. Note: when you switch the machine on, if you must erase the previously performed programme, it is also sufficient to press the �Fabrics� button and select a new programme. Press the �On/Off� button to switch the machine off. The relevant light will go out. Remove the laundry from the machine. Check whether the drum is completely empty, by rotating it with your hand. The purpose of this is to prevent any items of laundry from remaining accidentally in the drum, where they might get damaged in a subsequent wash (e.g. by shrinking) or bleed colour into another load of laundry. We advise you to close the water supply tap and disconnect the plug from the socket. Leave the door ajar in order to air the machine.
12. How to cancel a programme during its cycle
To cancel a programme that is being carried out, first pause the machine by pressing the �Start/Pause� button, then press the �Skip/Reset� button repeatedly, until the display shows three blinking dashes.
13. How to open the door during the cycle of a programme
You can open the door, after having set the machine to PAUSE, provided the following conditions exist: � the washing machine is not in the heating phase beyond 55°C; � the level of the water is not high; If these requirements are met, when you pause the machine the door can be opened. Should it not be possible to open the door, and should it be absolutely necessary to do so, switch the machine off by pressing the �On/Off� button.
