Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
Text excerpt from page 10 (click to view)
To select Drain only, press the �Skip� button three times, the wash - rinses - spin LED,s go out. The Drain LED only remains alight.
Prewash Wash Rinses
12 Programme phase indicator lights
When you select a programme, the lights relevant to the phases that form the programme light up.
Spin
Drain
Prewash Wash Rinses Spin Drain
11 �Delay� button
This button makes it possible to delay the starting of the programme selected from 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 23 hours. The delay you have selected is shown on the display for about 3 seconds; afterwards, the duration of the programme reappears. You must select this option after you have set the programme and before you press the �Start/Pause� button. The time value shown on the display will decrease by one unit every hour. You can change the delay time at any moment, before you press the Start/Pause button. If you have already pressed the Start/Pause button, and you wish to cancel the delay time, proceed as follows: � set the washing machine to Pause by pressing the �Start/Pause� button; � press the �Delay� button until the display shows the symbole «0�». � press the �Start/Pause� button again. Important! The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to Pause by pressing the �Start/Pause� button. The door locked light goes off. After you have closed the door, press the �Start/Pause� button again.
After you have started the programme, only the light relevant to the phase that is currently being carried out will remain lit.
